RTS KP95 Service Manual

INSTALLATION INSTRUCTIONSKP95-0 KEYPANELVERSION 8.2WITH EKPD-95 EXPANSION PANELADAM™, ADAM™ CS, AND ZEUS™ INTERCOM SYSTEMSClearOffCallAnswerTalkTalkOf

system, the keypanel should be ready for operation. Referthe station operator to the Keypanel Operation instruc-tions in the KP95-0 Operating Instruct

2.9.3 Terminal Block Connections(Reference Figure 6)AMP OUT + and - : These terminals provide the key-panel audio amplifier output signal to drive an

panel jumpers J404-J406 must be set for the type of mi-crophone (see "Internal Jumpers", page12).2.9.5 EXT LINE IN ConnectorAn external bala

3.1.1 J201 (EXTERNAL INPUT MUTING)When pins 2 and 3 are shorted, a signal input at the EXTLINE IN connector is muted when any Talk key ispressed. When

14 Installation Instructions, KP95-0 KeypanelP2J202J203J201P6J403J402J401Q402J406J404J405P4U203TP 407P1U309U302U305U314P10P11SW1Y301RV201RV204P5RV408R

4. Check the level at the MIC PRE OUT connector (refTable 6 for pin-out). It should measure +8 dBu.5. If the reading is not +8 dBu, but within a 3dB r

Headset Carbon-Mic Level1. Insert a -25dBm signal (1 KHz at 50 ohms) into thecarbon mic input of the HEADSET connector(reference Table 4 for pin-out).

8. Adjust RV204 (internal) for a minimum commonmode signal.9. Insert a +8dBu (1 KHz) signal into the EXT LINE INconnector and record the output readin

18 Installation Instructions, KP95-0 KeypanelAddress Intercom Port Numbers (8 Ports per Audio I/O Card)1 1 9 17 25 33 41 49 57 65 73 81 89 97 105 113

Installation Instructions, KP95-0 Keypanel 19NOTES

2 Installation Instructions, KP95-0 KeypanelPROPRIETARY NOTICEThe RTS product information and design disclosed herein wereoriginated by and are the pr

™

Installation Instructions, KP95-0 Keypanel 3

4 Installation Instructions, KP95-0 KeypanelThis page intentionally left blank.

Installation Instructions, KP95-0 Keypanel 5TABLE OF CONTENTSINTRODUCTION ·······························································7INSTALLATION

6 Installation Instructions, KP95-0 KeypanelLIST OF FIGURESFigure 1. KP95-0 Keypanel Reference View ··················································

1 INTRODUCTIONThis manual describes the installation of the KP95-0 Key-panel and EKPD-95 Expansion Panel. The manual isbased on version 8.2 of the key

2 INSTALLATION2.1 GENERALInstallation consists of the following general steps:1. Unpack and inspect the equipment.2. Check that the factory default ju

ADAM CS Intercom Systems: Use the appropriate plan-ning worksheet in the ADAM CS Installation Manual.(Refer to the List of Tables in the front of the