RTS 4010 User Manual

Model 4010Central ElectronicsUser ManualIncludes:Model 4001 Control Station for 4IFB, 1 SAModel 4001M Control Station for 4IFB, 1SA with MicrophoneMod

4Central Electronics – Model 4010The Central Electronics unit contains all the necessary control functions and electronics to provide the active link

5Splitter Assembly – Models 4022 and 4025AThe splitter assemblies connect the control stations with the central electronics via 25-pair cable with mic

6SpecificationsModel 4010 Central ElectronicsFrequency Response30Hz to 16kHz, +1,-2dBNoiseaInterrupt Channel, <-75dBuNon-Interrupt Channel, <-83

7CHAPTER 2InstallationStandard InstallationThe Central Electronics, Model 4010, is a rack mounted unit. The rear of the Model 4010 must be supported w

8The Stage Announce output is balanced and provides an average signal level of about -5dBu. See Figure 6. The program inputs accept balanced lines wit

9Expanding the Control Stations All FunctionThe IFB ALL button on the Control Station causes all of the IFB buttons to be activated. The SA button is

10The system may be expanded for up to 12 User Stations, three (3) Central Electronics, three (3) Splitter Assemblies, and four (4) Control Stations.F

11FIGURE 4. A Configuration – 3 System

12FIGURE 5. User Station Connection to the 4010

13FIGURE 6. Program Input and SA Output ConnectionsFIGURE 7. Balanced Mic Level Input

PROPRIETARY NOTICEThe product information and design disclosed herein were origi-nated by and are the property of Bosch Security Systems, Inc. Bosch r

14FIGURE 8. Unbalanced Mic Level InputFIGURE 9. Line Level Input

15FIGURE 10. Control Station Cable AssemblyFIGURE 11. Priority Connections to 4001 Control Station

16FIGURE 12. Priority Connections for 4002 Control StationFIGURE 13. Priority Connections for 4003 Control Station

17FIGURE 14. Speaker Muting ZonesFIGURE 15. Return IFB Connections

18FIGURE 16. Stereo-Mono IFB Selection

19CHAPTER 3OperationOperating InstructionsThe Series 4000 IFB System is very easy to use. The discussion below covers initial setup as well as the act

20Control Station Operation, Models 4001, 4001M, 4002, 4002M, 4003, 4003MTo use a Control Station, do the following: > Press the button or buttons

21Operating DistancesWith a telco pair, maximum operating distance averages 800 meters (1/2 mile). Doubling up the conductors in a telephone quad exte

Important Safety Instructions1. Read these instructions.2. Keep these instructions.3. Heed all warnings.4. Follow all instructions.5. Do not use this

TableofContentsIMPORTANT SAFETY INSTRUCTIONS ...

ListofFiguresFIGURE 1. Power Connection to Series 4000 Control Stations ...

3CHAPTER 1Introduction and SpecificationIntroductionThe IFB System is a one-way IFB (Interruptible Feedback)1 communications system (a program interru