RTS XCP-ADAM-MC User Manual Page 1

USER MANUALModel UIO-256Universal Input/ Output Frame9330-7499-000 Rev F, 02/2005

105.3 Fuse ReplacementThe fuse is accessible on the rear panel power moduleof the UIO-256. Remove the power cord from thepower module and free the fu

11

Telex Communications, Inc. • 12000 Portland Avenue South • Burnsville, MN 55337

2Proprietary NoticeThe RTS product information and design disclosedherein were originated by and are the property of TelexCommunications, Inc. Telex

3Contents1. Introduction ...

4Figure 1. UIO-256 Front and Rear Panel Features1. IntroductionThis manual describes the installation, programming,and operating procedures for the R

54.1.1 System Firmware 9.2.1 or NewerThe UIO-256 must be configured to work in Multi-Dropmode. Set DIP switch 1-2 to the CLOSED position. Upto 16 UI

6SW11 2 3 4 5 6 7 8OpenClosedSW11 2 3 4 5 6 7 8OpenClosedSW11 2 3 4 5 6 7 8OpenClosedSW11 2 3 4 5 6 7 8OpenClosed9-Pin50-P

7DE-9S(Female)DE-9P(Male)61212TO ADAM CS, J902TO: UIO-256, J2721TO: PAP-940,PAP-951, OR PAP-952DE-9P(Male)612TO: PAP-950-50DE-9P(Male)DE-9S(Female)DE-

8Relay Output Numbers*Relay Contact PinNumbers*** Dependent on UIO-256 DIP switch SW1 settings for Input/Output range as summarized in Table 1.** The

95. Operation5.1 Status IndicatorsActivating a keypanel key that is assigned to a GPIoutput will cause the appropriate OUTPUT STATUSindicator on the U