RTS RVON-I/O User Manual download pdf (Page 36)

Default Setup

Every attempt is made to ensure the board is shipped from the factory containing the following settings.

All are “set rvon” commands

There are more parameters the software will auto-configure if they have not been previously setup.

All are “set channel #” commands because they are for each audio channel.

Set Serial

When using Serial Pass-Through Mode, you must set the serial port you will use with the IP Address for the destination serial

pass-through port you are going to use. You must also set the baud rate at which data will be transmitted over the serial port

(DIP Switch 2 OPEN). For more information on DIP switches, see “Connection Diagrams” on page 5.

Set GPIO

When configuring the GPI/O on the RVON-I/O, there are three different mode options you may choose:

Pass-Through Mode for GPI/O:In Pass-Through mode, GPI/O status is sent over Ethernet, therefore you must set the IP

Address of the destination GPI/O pass-through port.

1 Keypanel (Single Port) Mode:In 1 Keypanel mode, also referred to as single port mode, all GPI/O on the RVON-I/O are

associated with only one keypanel. Associating the GPI/O with a keypanel allows you to access/address the GPI/O in UPL

Statements. Use the Set Panel parameter to designate which RVON-I/O port is associated with all the GPI/O’s on the unit.

COMMAN

DEFAULT VALUE DESCRIPTION

ip_addr 192.168.0.1 IP address for the RVON-I/O

netmask 255.255.0.0 Network mask for the RVON-I/O

gateway none Gateway IP address for the RVON-I/O

user telex RVON-I/O username for Telnet access.

password password

RVON-I/O password for Telnet access (8-40

characters).

vad_thresho

10 VAD Threshold

COMMAN

DEFAULT VALUE DESCRIPTION

dest_ip 0.0.0.0

Destination IP Address for this particular

channel.

dest_type 0

Destination type X = 0 (rvon-8), 1 (rvon-1), 2

(rvon-I/O)

dest_chan 0

Destination channel - the port on the far end (0-

chan_codec 0 Profile to use (previous coding table).

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 59 60

No comments

RTS RVON-I/O User Manual Page 36